66-77 Ford Bronco Fold and Tumble Rear Seat Installation

For video instruction, please see our Early Bronco Fold & Tumble Rear Seat Installation Video.

You can download these instructions as a PDF here: 66-77 Early Ford Bronco Fold and Tumble Rear Seat Installation

1. Remove Bronco’s rear seat mounting bolt from floor.
2. Remove the following parts from package.
   1. Bracket support seat LH
   2. Bracket support seat RH
   3. Bushing
   4. E clip
   5. Striker B
3. Install the bushing through bracket hole.
4. Put the bracket through the shaft pin, follow by clipping the e clip as shown in diagram

How to Install the 66-77 Early Ford Bronco Fold and Tumble Rear Seat

If rear seat belt holes are not there, situate the seats to your preference and mark holes to
drill. Make sure not to drill into the rear fuel tank.

Mount the safety latch bracket to existing rear center seat belt holes using the following
instruction.

Installing 66-77 Early Ford Bronco Fold & Tumble Rear Seat Lock

1. Remove seat belt anchor bolt from floor.
2. Position lock underneath seat belt and eyelets as shown.
3. Reinstall seat belt anchor bolt through seat belt eyelets and seat lock. (Do
   not tighten yet).
4. Align the seat lock with striker properly so the seat will lock when it is pushed
   down into position.
5. Tighten seat belt anchor bolts.
   With the seat situated square in the safety latch bracket, mark front bracket holes with felt tip pen, center punch marks, and drill holes. Make sure not to drill into anything important. Use bolts, lock washers and nuts provided to mount front brackets..

Wear seat belts at all times.

66-77 Early Ford Bronco Fold and Tumble Rear Seat Photos

66-77 Early Ford Bronco Fold and Tumble Rear Seat – Figure 1

Early Ford Bronco Fold & Tumble Rear Seat – Figure 2

The Latch on the Early Ford Bronco Fold and Tumble Rear Seat