Skip to main content
TOMS OFFROAD
Cart
Home / Resources / 66-77 Ford Bronco Transfer Case Yoke Installation
Drivetrain Instructions Updated 7/17/2023 4:51:41 PM

66-77 Ford Bronco Transfer Case Yoke Installation

Parts you'll need (reuse your yoke flat washer)
If installing new Transfer Case Yoke Seal, do so now. Seal should mount flush with housing. Grease inside of the seal.
Apply a thin film of grease to the yoke where the seal will ride.
This groove is where the o-ring seats. It prevents the oil from seeping out of the splines.
Install the o-ring into the groove as shown. The O-ring is only needed on FRONT output because it is below the full oil mark.
Install the Flat Washer (re-used from the old yoke).
Install the nut and tighten down. The nut must be tight for proper preload of the bearings. Per the Ford Truck Shop Manual, this nut should be about 125-150 ft/lbs.
Downloads file download icon Transfer Case YOKE Installation Instructions
Parts Needed
  • New transfer case yoke
  • O-ring
  • Top-lock nut
  • Yoke flat washer (reuse)

More Ways To Get Help & Learn More

Get In Touch
Don't ever hesitate to contact us if you have any questions about a product or instructions. We're always happy to help!
(541) 779-1339 info@tomsoffroad.com
Check Us Out On YouTube
Subscribe to our Tech Tips channel for even more how-to's and help!
Subscribe
Visit our blog
Everything a Bronco enthusiast could want, from community announcements and event roundups to Team Roaming Wolves updates and contests!
TOMS OFFROAD Blog
tomsoffroad76/ Facebook Twitter YouTube LinkedIn