Skip to main content
Updated 7/17/2023 4:19:27 PM

EFI Clutch Equalizer Bracket

The reason for using this bracket is that late model 5.0 and 5.8 motors have no provision in the block for the Bronco equalizer engine bracket. The EFI Clutch Equalizer Bracket provides a mounting hole for your Bronco equalizer engine bracket. We have found a few casting variations for late model blocks. In order to install the bracket minimal (5.0) to moderate (5.8) grinding or filing may need to be done to the block in the mounting area.

66-77 Early Bronco EFI Clutch Equalizer Bracket


  1. Remove the lowest bolt on the left side of the bell housing.

  2. Use a 7/16” drill bit and drill through the hole where the bolt was removed.

  3. Place the 7/16” x 4” bolt through the hole from the bell housing side.

  4. Test fit the new bracket onto the bolt and push the bracket up to the block. The bracket should sit flat against the block with the bolt hole close to the bell housing. You may see metal casting keeping the bracket from sitting flat. If so you will need to grind this area down in order for the bracket to be located correctly.

  5. Once the bracket is sitting correctly in place test fit the equalizer bracket. The 7/16” washers can be used to space the bracket away from the block towards the front of the motor if necessary.

Hardware to Install EFI Clutch Equalizer Bracket
  • 1 – 7/16” x 4” Bolt
  • 1 – 7/16” Lock Nut
  • 5 – 7/16” Flat Washers

More Ways To Get Help & Learn More

Get In Touch
Don't ever hesitate to contact us if you have any questions about a product or instructions. We're always happy to help!
(541) 779-1339
Check Us Out On YouTube
Subscribe to our Tech Tips channel for even more how-to's and help!
Visit our blog
Everything a Bronco enthusiast could want, from community announcements and event roundups to Team Roaming Wolves updates and contests!